...
The following special processing features are available for running z/OS tasks:
- Special Processing on z/OS Tasks#Using Using Variables in JCL and In-Stream Data Sets
- Special Processing on z/OS Tasks#Skipping Skipping Steps during Initial Run
- Special Processing on z/OS Tasks#Overriding Overriding Key JCL Parameters from Universal ControllerSpecial Processing on z
- /OS Tasks#Disabling Disabling Automatic Data Set Deletion
The following failure processing features are available for handling job failures:
- Special Processing on z/OS Tasks#ReRe-running a z/OS Task Instance
- Special Processing on z/OS Tasks#Interactively Interactively Ignoring a Step Code to Force a Task to Complete
The Controller supports compatibility with other schedulers:
- Special Processing on z/OS Tasks#CA7CA7/CA11 Toleration
The Controller provides the following reports that track error processing:
- Special Processing on z/OS Tasks#Viewing Viewing Re-run ReportsSpecial Processing on z/OS Tasks#Viewing
- Viewing Audit Trails on a Restart
Each of these features is described in detail below.
...
If you make any JCL changes, the Controller will prompt you for a confirmation, as described in Special Processing on z/OS Tasks#Re Re-run a z/OS Task Instance from a Specific Step, below.
During the confirmation process, UAG checks for the following JCL changes:
...
| Note | ||
|---|---|---|
| ||
By default, on a re-run, the return code in the restarted step will revert to the original return code. To retain the new step code, change the Retain Overridden Step Codes On z/OS Task Re-run Universal Controller system property to true. |
...