Description

The RUN FS JOB NETWORK command performs the following actions:

Defines a new SAP FS job network based on a USAP FS Job Network definition file.
Starts the defined FS job network.
Waits for the started FS job network to complete.
Purges the FS job network from the SAP system.

The exit code of usap will indicate the completion status of the FS job network.

See WAIT for FS JOB NETWORK Exit Codes in Universal Connector for SAP Exit Codes for a complete list of job status exit codes.

Command Line Syntax

The following figure illustrates the command line syntax of the RUN FS JOB NETWORK command, using the command line, long form of its configuration options.

-run {filename/ddname |

-jnetid

jobnetid

-jnetprcid

processid}

Command Argument

The RUN FS JOB command can be expressed as either:

-R (Short form)
-run (Long form)

The RUN FS JOB command argument, filename/ddname, specifies the name of the file that contains the FS job network definition.

See FS Job Network Definition File - USAP for additional information on the FS job network definition file.

Configuration Options

The following table describes all RUN FS JOB NETWORK configuration options and provides the command line, long form of each option illustrated in the RUN FS JOB NETWORK command line syntax, above.

Configuration Option Name	Command Line Long Form	Description
JOB_NETWORK_ID	-jnetid	Network identifier for the pre-existing SAP FS job network being started.
JOB_PROCESS_ID	-jnetprcid	Process ID of an existing SAP FS job network process to start.

Browser not supported